Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Cut 3D model from the centre and glue it back together?

4 REPLIES 4
SOLVED
Reply
Message 1 of 5
Anonymous
418 Views, 4 Replies

Cut 3D model from the centre and glue it back together?

Anonymous
Not applicable

Hello,

 

Sorry if this question is simple, I am very new the 3D modelling. 

 

I'm trying to remove two rows out of this test tube rack.

Since there are connectors at the side, I thought it might be easiest to remove two rows from the centre and then glue the rest back together? Is this possible?

See attached file.

 

Thanks for any help you can provide in advance! 🙂

0 Likes

Cut 3D model from the centre and glue it back together?

Hello,

 

Sorry if this question is simple, I am very new the 3D modelling. 

 

I'm trying to remove two rows out of this test tube rack.

Since there are connectors at the side, I thought it might be easiest to remove two rows from the centre and then glue the rest back together? Is this possible?

See attached file.

 

Thanks for any help you can provide in advance! 🙂

4 REPLIES 4
Message 2 of 5
etfrench
in reply to: Anonymous

etfrench
Mentor
Mentor

It will be easier to remove the two rows from the end.  If you had modeled this with Design History turned on, it would only take editing one or two parameters to change the number of holes and size of the stand.

ETFrench

EESignature

1 Like

It will be easier to remove the two rows from the end.  If you had modeled this with Design History turned on, it would only take editing one or two parameters to change the number of holes and size of the stand.

ETFrench

EESignature

Message 3 of 5
mango.freund
in reply to: Anonymous

mango.freund
Advisor
Advisor
Accepted solution

hello, @Anonymous , @etfrench anyway i am to late, but maybe you are interestet.

https://autode.sk/3vJG0Fy

greetings mango

 

0 Likes

hello, @Anonymous , @etfrench anyway i am to late, but maybe you are interestet.

https://autode.sk/3vJG0Fy

greetings mango

 

Message 4 of 5
Anonymous
in reply to: etfrench

Anonymous
Not applicable

Thank you so much! I'm sure your solution works as well, but I chose the other one just to avoid changing the support connections! I got this 3D model from a template off of Thingiverse so I was worried I would ruin the supports! 🙂

0 Likes

Thank you so much! I'm sure your solution works as well, but I chose the other one just to avoid changing the support connections! I got this 3D model from a template off of Thingiverse so I was worried I would ruin the supports! 🙂

Message 5 of 5
Anonymous
in reply to: mango.freund

Anonymous
Not applicable

Your solution worked! Thank you so much 🙂 

0 Likes

Your solution worked! Thank you so much 🙂 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report