Assembly Joints Issues

Assembly Joints Issues

Anonymous
Not applicable
286 Views
2 Replies
Message 1 of 3

Assembly Joints Issues

Anonymous
Not applicable

I am having issues with a joint for the back of a car seat. It states there are joint conflicts but the back rest will still move. 

0 Likes
287 Views
2 Replies
Replies (2)
Message 2 of 3

jeff_strater
Community Manager
Community Manager

I'm not sure what the issue is with this joint.  However, I did notice that if I deleted it, the seat back seems to be locked already, so I'm not surprised that adding a revolute joint would fail.  I don't understand why the seat back moves after the joint, to be honest.  My guess is that some other joint is getting ignored because of the warning. 

 


Jeff Strater
Engineering Director
0 Likes
Message 3 of 3

jeff_strater
Community Manager
Community Manager

OK, I found the problem.  The "RigidGroup2" inside of "Seat Assembly" constrains the same components as Rev9 in the top-level design.  This is the conflict.  Deleting RigidGroup2 got rid of the warning on the revolute joint

 

Screen Shot 2021-12-06 at 3.15.56 PM.png


Jeff Strater
Engineering Director
0 Likes