Hi everyone!
I am trying to set up the joints so I would obtain a similar motion as shown in the picture. Would it be possible to reproduce the "jumps"? Otherwise I would be happy to be able to smooth-slide both pins through the slots without the adjustable slots?
Thank you in advance 😃
I am extremely sad to say, Fusion 360 does not support a Pin-Slot joint along a radius. This applies to the Slider joint as well. I hope this will be coming soon.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
