Fusion
Community
There's a request on the ideastation that I think is a bug so thought I'd make a post here to demonstrate.
The problem is if you open a design, activate a flat pattern then export as a DXF the file is flagged as edited and if you have autosave enable you get a new version. This can cause a lot of problems if the design is part of an assembly and\or has a 2d drawing as they will then need updating. The reason I think the is a bug is there's no problem just activating a flat pattern then exiting the flat pattern, it's only if you export the DXF the file shows as edited.
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Any simple sheet metal part will do, see attached.
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
