Sprung joints

Community

Forums

This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. Translate

Status:

When you are assembling a spring or spring clip to another component and there needs to be a spring value by over bending fold could this be added. This would function in a flat spring clip type component where the drawing shows a finished angle of fold which would be less in un sprung form as shown in attached image

Forums Links

All Forums
Getting started
Contact Support & Downloads
Autodesk Education Support
Trial Support
Autodesk University Home

Can't find what you're looking for? Ask the community or share your knowledge.

Submit Idea