Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Opening a Sketch automatically limits the SpaceMouse control to ZOOM and PAN, and prevents any navigation input that would cause an ORBIT. This could be a setting where you pick which navigation controls should be enabled on a workspace to workspace basis. This can be done by opening the SpaceMouse settings and un-checking the right boxes but it takes too long if you're only going to be in a sketch for a few seconds.
