Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson07-31-201611:39 AM
Status:
RUG-jp審査通過
More Control Over Display of Origin and Default Planes For All Workspaces
Allowing finer control over the display of default construction geometry (origin and planes XY, XZ, and YZ) onto the canvas from inside the Browser. This would make it very helpful in giving the engineer a good point of reference when one is needed. When default construction geometry is set to on from the Model Workspace the following other Workspaces do not display default construction geometry on the canvas nor are display controls given in the browser: Animation, Simulation, CAM
Hey there! Thanks so much for submitting your idea. Unfortunately, this idea did not get a lot of votes from the community, and now is 2 years old. We're changing its status to archived. If you still feel strongly about this idea, you can resubmit it. Check out some idea submission best practices here: https://forums.autodesk.com/t5/community-faq/ideas/m-p/5384681#M44
