Community
This was prompted by a specific issue, but it's a very general problem.
I tried extruding a sketch [works] with 5º of draft [fails]. All F360 reports is the following:
Aside from being annoying [there is no obvious pathology in my sketch that should cause drafting to fail], this is completely useless.
Don't just say «I can't do that» - tell us why so we can fix the issue.
Addendum: as I was writing this, F360 crashed yet again
I realise it's a lot to ask, but it'd be great if the program was more stable than a house of cards.
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Submit Idea
