I'm seeing requests for this going way back, the earliest i read was 2015 but I'm sure there is more. So I'm taking a photo from a tall vantage point, good focus, and so angle loss to camera lens geometry is minimal. I add that to fusion canvas, calibrate, and draw on top of it to find hole pastern to make a case for a custom computer build.
What I would really like at this point are the following.
- permanant and changable calibration points (ie two horizontal for width scale, and two vertical, or on an angle to establish height), these should project to a sketch, allowing the sketch to remain in alignment & scale
- horizontal/vertical alignment calibration (ie two points that are on the same horizontal plane)
- the ability to change opacity on the fly (shortcut key ctr-pgup/down or something...)
It might be easiest to just allow import canvas into a sketch plane, add a few calibration point/circles/rectangles/etc, and contrain those with dimension, changing the dimensions would scale those images, and a large part of the drawing proportionally. All the other functions above would just follow along.
Anyway, improving these features are a big deal and should have been addressed a while ago.
