Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson04-22-201804:31 PM
Status:
Gathering Support
Add ability to show CAM zero in a drawing
I'd like to be able to show the CAM zero in a drawing derived from a design so that I can document where the zero was set up for designs I hand off to someone else for machining without requiring them to go look at the original design, just be able to load the .nc, and refer to the drawing in the work ticket.
