Community Search
Didn't find what you're looking for?
Ask the community.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
11 results
Sorted by:
Hi, How to make and represent a zoom in a drawing in inventor 2015? I would like to make a circle around a specific zone of my part, then another circle with the zoomed part, and a line join...
We have had 2013 for about 2 months and with both of the projects I'm working on I commonly get the message when I load: "Errors detected. Do you want to close and use recover?" When I do there are g...
Hello, I have atached the file I'm working on. Could any one help me? I am trying to make this a solid (that is .25" thick) do I have to make it a surface before I can mak...
This morning I opened up an IDW that I have been working on for the last few days. The first 3 sheets of the drawing are fine, but the fourth and fifth sheets appear like so. Has anyone seen an...
Here is what seems like a simple question. I have a cutom title block that automaticly places material, status, stock number etc. of the component in the drawing sheet, but I am st...
Wish list: 1. I wished the browser bar would stay on the 2nd monitor on my dual monitor system instead of moving to the center of my first monitor when I save my assembly. 2. I ...
I'm hoping for a simple fix. I imported a half completed design(Autocad) into an Inventor assembly file and started to make changes to the part using the hole command and I found t...
I was given the following part, and I need help completing it. I am totally out of my league with this one: The radius' of the bend are all different. The part has a twist. I'm pulling my hair ...
This is my first attempt at making a whisker sensor. All went well until the curved area between the coil and the stem. I attempted a a sweep using the end of the coil and the 3D sketch. no good. th...
One annoying thing about Inventor drawings that I noticed back using Inv 2013, was the tangent line default, off, with no way of turning it on. 95% of my drawings really need the clarit...