Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

h_ahmedDA5CD
en respuesta a: h_ahmedDA5CD

Hi @LeoWarren-EDU & @TravisNave for the suggestions, apologies I have not had time to respond. 

So @TravisNave we went to see what would happen if the program was launched as admin to see if the license automatically registers as a network License. However we have then been loaded with an error message to state that our installed version of Network License Manager is unsupported. Upon checking our LMTools version is 1.18 which is supported, but the flex Daemon is using version 1.16 which is not supported. 

Once I have updated LMtools using the link Network license installation | Admins | Autodesk Support, I'll come back to you with an update, thanks again for the advice provided thus far.