Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
316 Vistas, 1 Respuesta

Orthomode ignoring Specified Units for Distance?

I was attempting to draw a 5x5 square, but even if I was using orthomode, it seem to disregard any units I specified to move from the starting point. In this situation, I selected the line tool, chose my starting point, shifted my cursor to the right, pressed "5," and pressed "Enter," but there was no line going 5 units to the right. Instead, there were no visible changes.  In terms of settings, I just had my grid and orthomode activated.

 

I'm not sure if there was something wrong with my settings, since I saw zero degrees listed near my cursor after pressing "Enter." In addition, I attempted to do the same thing with both autosnap and osnap on. Plus, I also had recently activated "filedias" since I was struggling with previous drawings and I have the student version. 

 

If I was not following the proper procedures to drawing lines within specific units with orthomode, please let me know. Thanks in advance!