Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

jimbir
en respuesta a: jimbir

This is the chart I spoke about earlier and I've also included a copy of the command history.

 

COMMAND I ENTERED

WHAT I SEE ON THE COMMAND LINE

Type SPLINE – hit enter

Specify first point or [object]:

Select first point  (#1)

Specify next point:

Type T – hit enter

Invalid point - specify next point:

Select next point  (#2)

Specify next point or [close/fit tolerance] <start tangent>:

Select next point  (#3)

Specify next point or [close/fit tolerance] <start tangent>:

Type tangent – hit enter

To

 

This is a copy of the command history

 

Command: _spline

Specify first point or [Object]:

Specify next point: T

Invalid point.

Specify next point:   (1)

Specify next point or [Close/Fit tolerance] <start tangent>:   (2)

Specify next point or [Close/Fit tolerance] <start tangent>: TANGENT

It’s at this point where the wheels come off the wagon and, even though I type a few more commands, I get nowhere. I tried to continue by typing the commands below but the results shown on the drawing made no sense to me.

to NEA                                                                                                                                                           

Point or option keyword required.                                                                                   

Specify next point or [Close/Fit tolerance] <start tangent>: _endp of           

Specify next point or [Close/Fit tolerance] <start tangent>:

Specify start tangent:

Specify end tangent: