04-11-2019
05:33 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
04-11-2019
05:33 AM
I've already tried several different settings with -dwgunits
Whether scale upon insert is set to yes or no, or match INSUNITS to drawing units is set to yes or no (of different combinations there of) doesn't make a difference.
If I set the insert units in options to millimeters for source and inches for target, or unitless for both it doesn't make a difference.
I've been purging after every attempt to make sure I don't have any remnants of anything.
Starting from a blank drawing yields the same results.