03-12-2019
03:28 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
03-12-2019
03:28 PM
Cóno Excéntrico
Hola
Alguien sabe cómo se crea un cono sólido excéntrico truncado?
Probé con el comando SWEEP y no me da
Cualquier duda al jpg attached.
Muchas Gracias
Daniel Avila
Hydraulic Eng.
Hydraulic Eng.
03-12-2019
03:37 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
03-13-2019
06:01 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
03-13-2019
06:01 AM
Thank U again Kent
I did it (the oblique cone)
I take the opportunity to ask you, What are the difference between the LOFT and SWEEP 3DTools commands?
I did it (the oblique cone)
I take the opportunity to ask you, What are the difference between the LOFT and SWEEP 3DTools commands?
Daniel Avila
Hydraulic Eng.
Hydraulic Eng.
03-13-2019
09:38 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar