Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
en respuesta a: david.weeda

Hello David

Sometimes it's just too complicated to perform in one step.  I broke the items into section into 3 by slicing them at the point of chamfer at each end.  I then sliced the excess away from each end of the longer item.  Once sliced it was possible to intersect each pair of items individually.  when all the items were intersected I then used union on them to return to one single component.

By breaking this down into easy steps the processing was able to complete the final item.

There are a couple of sharp points at each end you may wish to slice off the model.

I hope this is useful - probably too late for this problem but the process of breaking it down into manageable sections can be useful in many circumstances.