Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
5506 Vistas, 4 Respuestas

Unblocking a block

I have a call center floor plan and need to reconfigure several cubicles however, who ever created the blocks did not allow exploding the blocks. how do I unblock a blocked floor plan.  

beyoungjr
en respuesta a: Anonymous

Can you edit the block used?  Select the block and right click to choose block editor.  If you must keep the originals then just save the block as a new name before leaving the editor.  Then insert the new block where you need it.

 

Blaine

 


Blaine Young
Senior Engineering Technician, US Army

rkmcswain
en respuesta a: Anonymous
GrantsPirate
en respuesta a: Anonymous

Start the BLOCK command, pick the block name in the list, add a check mark for Allow Exploding, pick OK, pick Redefine Block.  You are done.


GrantsPirate
Piping and Mech. Designer
EXPERT ELITE MEMBER
Always save a copy of the drawing before trying anything suggested here.
----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.

Kent1Cooper
en respuesta a: Anonymous

Or, so you don't need to know the specific Block name for each one to pick it from a list, double-click on an insertion of a Block to call up the Block editor, accept the offered Block name as the one to edit, and in the Properties palette, change the "Allow exploding" slot [toward the bottom] to say Yes instead of No, and Close the Block Editor.

Kent Cooper, AIA