09-25-2018
02:28 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
09-25-2018
02:28 PM
Hi,
please follow these steps:
- create an UCS in your current dwg-file, the coordinate system you want to get the coordinates for in your table.
- Then run command _COPYBASE with point 0,0,0
- Now create a new drawing
- Run command _PASTECLIP with point 0,0,0
- From that new drawing run command _DATAEXTRACTION
HTH, - alfred -
------------------------------------------------------------------------------------
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------

(not an Autodesk consultant)
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------
(not an Autodesk consultant)