08-13-2018
02:44 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
08-13-2018
02:44 PM
Been working with hatch and layer transparency fairly frequently. Never had a problem with this feature working until today. Doing a revision to an existing drawing and after plotting I noticed the 50% transparent layer was plotting too dark. I checked the page setup, and "Plot Transparency" was checked. Transparency Display is 'On', so I see the transparent layer in the viewport. I went back to my original drawing to make sure I wasn't seeing things, and sure enough the plot from 2 weeks ago showed the transparent layer at 50%. Today I cannot get the same .dwg file to plot properly. Anybody have a clue what my fat fingers pressed by accident this time...lol?
Thanks,
Alan
¡Resuelto! Ir a solución.