02-01-2018
10:14 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
02-01-2018
10:14 PM
@Anonymoushello, just in command prompt FILLET between two lines or circle (set fillet radius to zero). thanks
Remember : without the difficult times in your LIFE, you wouldn't be who you are today. Be grateful for the good and the bad. ANGER doesn't solve anything. It builds nothing, but it can destroy everything...
Please mark this response as "Accept as Solution" if it answers your question. Kudos gladly accepted.
02-02-2018
01:08 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
02-02-2018
01:08 AM
Hi,
i don't know how did you prepare your drawing ( from AutoCAD or imported from other software ) !! your drawing is consist from mini attached lines even at arc areas !!! this is not right you must have Lines,Arcs and splines maybe if needed . what i want to say is to redraw your lines more accurately and with arcs ( where needed ) . improve the way that you're follow to draw and improve your technique . ![]()
All the best,
Imad Habash