11-18-2017
03:17 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
11-18-2017
03:17 PM
Hi Iminardigmail,
As far as I know in geometry, there can be only one specific point that Point D can lie due to the constraints of lines on points. I have attached a screenshot as close to my goal as possible but it is not completely accurate.
If I move one line, another line will move off the point. I was hoping AutoCAD could control this in some way with parametric modelling.
Best regards,
Chris