Anonymous
1616 Vistas, 10 Respuestas
08-18-2017
07:57 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
08-18-2017
07:57 AM
We're using Release 2018.
At the top, above the Ribbon is where our LAYER display is located.
It's way to short. Shows only 16 characters.
We didn't have this short display when we were using Release 2005.
When we highlight an object to find out which layer it is on, the display is too short.
We then have to go to Properties.
But even that is too short to show the whole layer name.
We have to move the cursor over the layer name to see the whole name.
Way too many steps to solve a problem that wasn't in the older AutoCAD.
Is there any way to lengthen the display?
Read Ya Later -KLYPH
¡Resuelto! Ir a solución.