04-13-2017
11:19 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
04-13-2017
11:19 PM
Hi,
run command _UNION to create one solid from them, then again start export.
...or use the attached STL (which contains 3 solids from your drawing (there were not just 2)
- alfred -
------------------------------------------------------------------------------------
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------

(not an Autodesk consultant)
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------
(not an Autodesk consultant)