Anonymous
655 Vistas, 10 Respuestas
06-24-2016
11:51 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
06-24-2016
11:51 AM
OK, I'm new to ACAD17. I am trying to draw a simple line from say 100,100 to 110,110. I choose line, type 100,100 as start point, then when I try to type the second point a little box pops up which will only allow the first part of the second coord (say 110) to be entered (not 110,110). I can't get it to allow me to type the second coord in the command line. Since drawing lines from point a to point b is the most basic of acad actions I think I must be doing something wrong at a fundamental level. Any ideas? Sorry for being so obtuse.
¡Resuelto! Ir a solución.