10-31-2016
11:59 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
10-31-2016
11:59 AM
I suspect the limit is based on a supposition that all entries will be surface meshes (or potentially solids) of some sort. Theoretically a design could be made in AutoCAD with ZERO polygons but may or may not meet the requirements due to conversion; different curve resolutions would create models with differing numbers of polys.
----------------------------------
If you are going to fly by the seat of your pants, expect friction burns.
"I don't know" is the beginning of knowledge, not the end.

If you are going to fly by the seat of your pants, expect friction burns.
"I don't know" is the beginning of knowledge, not the end.