04-26-2016
09:00 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
04-26-2016
09:00 AM
Thanks in advance to everyone for your help. I am using autocad 2016. I am attempting to show a dim angle at greater than 180 degrees. I understand the way to do this is to select the vertex and then select the end points. When I select dim angular it doesn't allow me to select the vertex. Is there something special I need selected under snaps or something? Thanks again.
¡Resuelto! Ir a solución.
04-26-2016
09:21 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
04-26-2016
09:21 AM
@DanielkrampenV8756 wrote:
Thanks in advance to everyone for your help. I am using autocad 2016. I am attempting to show a dim angle at greater than 180 degrees. I understand the way to do this is to select the vertex and then select the end points. When I select dim angular it doesn't allow me to select the vertex. Is there something special I need selected under snaps or something? Thanks again.
Post your dwg.
04-26-2016
10:00 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
04-26-2016
10:20 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
04-26-2016
10:20 AM
I figured it out. If I right click it allows me to then select the vertex.