10-02-2024
07:39 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
10-02-2024
07:39 AM
CONVERTPOLY problem
I have a R14 DWG file that has about 400 POLYLINEs. I am trying to convert them to LWPOLYLINEs using CONVERTPOLY. When I select any of the polylines I get a message saying "0 polylines converted". If I draw a new POLYLINE in this drawing the CONVERTPOLY command works properly and converts it to a LWPOLYLINE. This drawing was created by a non Autodesk application. I have attached a drawing with one of the plines. I have tried opening the drawing with PLINETYPE set to 0,1,2 and no change. Any suggestions as to how to convert these plines to LWPOLYLINEs? And yes I am using R14.