02-11-2016
09:18 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
02-11-2016
09:18 AM
Since you have Ortho on and you want to just use direct distance entry you should be typing this instead
Line
pick point
pull cursor in direction desired
type 5'
hit enter.
The way you are doing it you are specifying a location of 5',0" and so the line goes from where you first picked to that coordinate.
Without Ortho on you could use
line
pick point
@5'<0
but there wouldn't be a need to do that with ortho on as shown above.
GrantsPirate
Piping and Mech. Designer![]()
Always save a copy of the drawing before trying anything suggested here.
----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.