Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
en respuesta a: martti.halminen

Hi Martti,

Thanks for the reply.

Yes and it is that exact page i have used when writing my dxf code for a table. However it is not possible to debug (at least i have not found a way) a piece of DXF code. So i was hoping either someone had tried to do what i am doing or maybe someone had a piece of advice of what i could try and do. Other than doing the DXFOUT option.

 

/Sam