11-25-2023
03:51 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
11-25-2023
03:51 AM
Hello everyone,
When I offset a self-intersecting polyline, AutoCAD trims the offset where it crosses the original polyline. Currently, there isn't a system variable that I can set to turn off this trimming behavior. Is there a LISP routine that can offset a self-intersecting polyline without trimming the offset at the intersection points as shown in the attachment?
¡Resuelto! Ir a solución.