Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Kent1Cooper
en respuesta a: pendean


@pendean wrote:

....

The areas you are trying to hatch must be flat (Z=0).

....


A small correction:  they don't need to be Z=0.  They can be at any elevation, but they just need to be Z=all-the-same for a given Hatched area.  However, the Hatch pattern will be drawn at the current drawing elevation, whether or not that is the elevation of the boundary object(s).  Here:

Kent1Cooper_0-1689613896873.png

the red square is the boundary for the green Hatch pattern, and the red is at elevation Z=1, but the current drawing elevation is at Z=0 [WCS], and that's where the green Hatch pattern goes, whether I Hatch it by picking inside or by object selection.

Kent Cooper, AIA