- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Hello,
I have a floor plan that was divided into areas: A, B, C, etc. and each area has its own dwg file.
I want to put all the areas into one file, but I do not know the base point when the Architect separated the complete floor plan.
Is there a way to do this that is NOT insert, and/or copy/paste since it's too much time consumming to find the joining point?
Thanks in Advance.
¡Resuelto! Ir a solución.
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
I would xref (external reference) them at 0,0,0. See what happens. Everything might be set up correctly and you will be happy.
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
@edna_guadiana-villarreal wrote:it's too much time consumming to find the joining point?
It shouldn't be that hard because, if the split was done properly, there will be a slight overlap between the part plans. If not, it's just a matter of connecting endpoints. You could have been done by now.
Rob
Drafting is a breeze and Revit doesn't always work the way you think it should.
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar