Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Kent1Cooper
en respuesta a: spetropoulos

Change the LTSCALE setting for the drawing to something smaller -- it was at 20, but if changed to 1, and with the linetype scale of that saw-cut perimeter changed to 0.05, and with linetype generation enabled for it, even without changing the Units to Meters I get this:

Kent1Cooper_0-1650387301270.png

Also investigate the PSLTSCALE System Variable.  With that set to 0 instead of 1, and the linetype scale of that perimeter to 0.5, the same "look" results.

Kent Cooper, AIA