10-21-2021
03:03 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
10-21-2021
03:03 AM
I am drawing a pipeline and I need to show joints in a pipeline. Joints must be shown as a line perpendicular to pipeline. What I’m currently doing is: firstly COPY joint in the place, then displace, rotate perpendicular to line and doing this all over again. In huge drawing I’m repeating this many times and it’s very exhausting. Another way is doing ARRAYPATH, but in short branches it’s not practical. And also this does not evaluate bends and branches. Is there a smarter way to do this?
Example attached.
¡Resuelto! Ir a solución.