Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

maxvasher
en respuesta a: Patchy

I thought that might have been the solution as well. The problem with
selecting all of the contours is that the ability to manipulate any of the
axises goes away from the properties box and there is therefore no way to
change them. I can select a piece of a contour line ( the contours
themselves seem to be made of several lines instead of one polyline) and
then change the z axis of it. Sometimes the whole piece moves to the 0 z
axis some times just one end of it. It will be a quite cumbersome method if
I am forced to go that route. There must be an easier way.