Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
en respuesta a: imadHabash


@imadHabash wrote:

Hi,

>> and the top view because the rest of the drawing is 2D .

i wonder here ... are you talking about making 3d models ( Solids, surfaces and mesh's ) or just make isometric by ISODRAFT command ? 

 


IMG_20201012_131722.jpg

 It is just isometric but not using isodraft. Cause ISODRAFT makes u draw in 2 direction not three and also in this case to draw circle u should use ELLIPSE. I wonder if there is any way to draw in three direction in top view. And I think there is, as attached the circle seems as circle in isometric using CIRCLE order as shown in properties.

Sorry I know it is comblex and hope I was obvious.