- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
semi-truck back-up turning radius
I have a CAD template for a semi-truck (WB-67) forward turning radius.
Can I use the same template for this semi-truck when backing-up?
I've been looking all over the internet for this information to no avail.
Thank you.
Chris B.
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Otherwise your post's title makes no mention that you have the Autodesk Vehicle Tracking software: do you? It is free for most current paid subscribers (not legacy/ maintenance folks).
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
The path of the vehicle is the same forward as backward. The key parameters in designing path requirements are:
Vehicle Turning Circle
Vehicle Steering Angle
Vehicle Wheelbase
These values are constant for vehicles regardless if you are moving forward or backward, now the driver's skill adds a whole other dynamic to the equation :).
Best Regards
Tim Crouse
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Thanks a lot Tim, your answer is exactly what I needed to know!!!!!!
By the way, I checked the Vehicle Tracking software, it is great; too bad it is too expensive.
Chris B.
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar