02-28-2020
03:22 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
02-28-2020
03:22 PM
Hi,
extrude your letters,
increase the extrusion of the arc-based solid.
run command _INTERSECT with the extruded letters and the red solid.
Is that what you are looking for (file attached)?
Not sure if this exactly what you needed, but could be a start ![]()
- alfred -
------------------------------------------------------------------------------------
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------

(not an Autodesk consultant)
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------
(not an Autodesk consultant)