Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

GrantsPirate
en respuesta a: barry2104

I too have been using F1 key for endpoint for years.  I had no problems until 2019 release or perhaps 2018.  What I do is let Help pop up, minimize it on my second screen by dragging the corner of the window and go on about my work.  I have searched for a solution myself and never found one, and I have my function keys defined in a partial customization file.  Even if I close the Help window the F1 = endp will work fine for a while and then will once again it will start opening the Help window.


GrantsPirate
Piping and Mech. Designer
EXPERT ELITE MEMBER
Always save a copy of the drawing before trying anything suggested here.
----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.