01-10-2020
02:03 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
01-10-2020
02:03 AM
Hi,
>> Basically I am just wire framing everything out.
That means you have just lines and arcs, horizontal ones in the XY-plane and then lines along Z, is this understood correct? If yes, then:
>> Is there any disadvantage to drawing this way? My main
>> concern is when I run this drawing through a CNC
>> machine, how will the program interpret my drawing?
Absolutely yes, the CNC program does not see surfaces which it definitely needs.
- alfred -
------------------------------------------------------------------------------------
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------

(not an Autodesk consultant)
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2025
------------------------------------------------------------------------------------
(not an Autodesk consultant)