05-04-2020
02:28 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
05-04-2020
02:28 AM
Hello everyone, my DWG is in millimetres. I would like to annotate certain tabs in Centimeter only without displaying alternative units. Is there a way to set a dimension style with primary units set to a multiple that would annotate in Centimeter?
¡Resuelto! Ir a solución.
05-04-2020
02:59 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
05-04-2020
02:59 AM
Modify dimension style: on Primary units tab set Scale factor to 0.1
You can also optionally add cm suffix on the same tab.
Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.
Maxim Kanaev
Architect
MARSS
Etiquette and Ground Rules of Autodesk Community
You can also optionally add cm suffix on the same tab.
Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.
Maxim Kanaev
Architect
MARSS
Etiquette and Ground Rules of Autodesk Community
05-05-2020
11:00 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar