Anonymous
1378 Vistas, 1 Respuesta
03-30-2017
12:41 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
03-30-2017
12:41 PM
I have a fully made 3D object and I want to make isometric and orthographic views (Top,Front and Side).
I think it uses Layout but I'm not fully sure of how to make them.
Also is it possible to make some writings at the corner as shown in the photo below?
¡Resuelto! Ir a solución.
03-30-2017
01:33 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
03-30-2017
01:33 PM
Hi,
In AutoCAD for Mac you can use SOLVIEW - SOLDRAW commands combination to accomplish this task.
Than you can put annotations in the Layout.
Here are two links to short tutorials about SOLVIEW -SOLDRAW :
https://m.youtube.com/watch?list=PLbZdxvrsUOyw9E1ZRq2Ibfdh1AIFHwJDC&v=U6VM06GSLWg
https://m.youtube.com/watch?list=PLbZdxvrsUOyw9E1ZRq2Ibfdh1AIFHwJDC&v=DatDMl6X3SA
Maxim
Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.
Maxim Kanaev
Architect
MARSS
Etiquette and Ground Rules of Autodesk Community
In AutoCAD for Mac you can use SOLVIEW - SOLDRAW commands combination to accomplish this task.
Than you can put annotations in the Layout.
Here are two links to short tutorials about SOLVIEW -SOLDRAW :
https://m.youtube.com/watch?list=PLbZdxvrsUOyw9E1ZRq2Ibfdh1AIFHwJDC&v=U6VM06GSLWg
https://m.youtube.com/watch?list=PLbZdxvrsUOyw9E1ZRq2Ibfdh1AIFHwJDC&v=DatDMl6X3SA
Maxim
Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.
Maxim Kanaev
Architect
MARSS
Etiquette and Ground Rules of Autodesk Community