12-22-2016
09:00 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
12-22-2016
09:00 AM
That is very typical for DWG files that have data from vertical products like Map3D or Civil3D. Note that this isn't limited to drawing objects (proxy objects for surfaces and so on) but also applies to data stored at the drawing level. You may need to use -EXPORTTOAUTOCAD command to remove these.
----------------------------------
If you are going to fly by the seat of your pants, expect friction burns.
"I don't know" is the beginning of knowledge, not the end.

If you are going to fly by the seat of your pants, expect friction burns.
"I don't know" is the beginning of knowledge, not the end.