Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
454 Vistas, 5 Respuestas

Degree direction messed up

No matter what command or option I set, Autocad LT will always set 90 degrees south and 270 degrees north. It always revolves clockwise and it's driving me draving my crazy.

 

I've tried angdir command set to 0, no good

In the Units tab the angle direction is not set to clockwise but still is clockwise.

maxim_k
en respuesta a: Anonymous

Welcome to Autodesk Forums!

Hi,

Does this happens in all drawings? Or just in one?
Have you tried to restart AutoCAD (quit it with QUIT command and launch again)?

Maxim

Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.


Maxim Kanaev
Architect
MARSS

MacACAD | Linkedin

Etiquette and Ground Rules of Autodesk Community
Anonymous
en respuesta a: maxim_k

Yes, it happens with all drawings. I've tried un-installing and re-installing.

 

maxim_k
en respuesta a: Anonymous

What about reset? Have you tried to reset AutoCAD options from the Application tab of the AutoCAD preferences?

Maxim

Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.


Maxim Kanaev
Architect
MARSS

MacACAD | Linkedin

Etiquette and Ground Rules of Autodesk Community
Anonymous
en respuesta a: maxim_k

Yes behavior is the same after a prefrence reset

maxim_k
en respuesta a: Anonymous

Are you sure you are using correct UCS in your drawings?

Maxim

Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.


Maxim Kanaev
Architect
MARSS

MacACAD | Linkedin

Etiquette and Ground Rules of Autodesk Community