Anonymous
en respuesta a:
Anonymous
05-01-2017
12:26 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
05-01-2017
12:26 PM
Yes, but I don't like it there. If you post a program for a lathe, it
is so far to the right, that I have to drag the window over just to
reach it. I don't normally even look at the code, I just want to save
it , but now I have to run the post processor, then save it. Just an
extra wasted step. Thanks
--
Mike Moore
CNC Programmer
American Tool and Machining
Office #(501)268-7011
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
is so far to the right, that I have to drag the window over just to
reach it. I don't normally even look at the code, I just want to save
it , but now I have to run the post processor, then save it. Just an
extra wasted step. Thanks
--
Mike Moore
CNC Programmer
American Tool and Machining
Office #(501)268-7011
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus