Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

bmarkeyJ44PH
en respuesta a: qpeturnKVRK6

Yes,  the tip is the same size as the bottom of the groove, .0625 in this case.  

 

Actually I changed it a small bit, changed bottom radius to .039 in hopes that might help.  

I have it to almost finished but no matter what I do I can't get a finish pass to go to the full depth.  

 

I wrote a quick program to rough with the 10d taper down to .765 which is almost final depth, .769.     Every finish operation I try doesn't want to go lower than around .695.