Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

gvinplen
en respuesta a: bhorstTGM48

Thank you @bhorstTGM48 for your reply.I watched some video clips on YouTube and I noticed that their starting position along the Z axis is constant or with very little variation. If the pitch of the thread is, say, 2mm and I have 3 starts of that thread, then F6.0 (2mm pitch X 3 thread starts), is constant for me and the position of the Z coordinate changes. . Let's say it starts with Z=1mm, then Z=3mm, then Z=5mm. Now if we implement this for a knurling surface of some diameter of 20mm, where let's say the thread pitch is calculated as 50 and then my Z would be Z=1mm, then Z=51mm, and then Z=101mm and so on. Something is not right. The G32 command does the same as G76