Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

kgueorguiev
en respuesta a: kgueorguiev

Nope, never found a good explanation for the gouges. It wasn't the tool holder; all the finishing tools were sticking out pretty far because of the deep cavities on the side I had to reach down into with those tools. I would expect gouging caused by the tool holder to first show up on the top face of the part, and closer to where the deep cavities are. The only thing I really did differently in this program that I don't usually do is reduce Relative Retract Clearance from 0.5" to 0.1" - Since then I haven't changed this setting from the default and have not seen these types of gouges.