Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

bgriesel
en respuesta a: serge.quiblier

Thank you for your response.

That did reverse the Z but it was not the issue I was having. I was able to get a posted file that was close by delving deeper into the actual programming, a little of post modifying, and manual editing. The one Z issue was mostly because I did not see some of the default settings for Z rapid plane and plunge clearance and such since they are not asked when defining the cycle, and require looking through all the tabs in the properties of each cycle setup.

 

Thank you again